Products
Oily putty D-NZ-10
Category:
Exterior Wall Putty Series
Tel:
E-mail:
Introduction
Product Description
This product is a two-component putty consisting mainly of special alkali-resistant resin, fillers, additives, and polyisocyanate, which can be used as a special sealing putty for fluorocarbon paint coating imitation aluminum-plastic panels or high-grade flat coating of fluorocarbon color paint.
Product Features
Excellent adhesion.
Acid-resistant, alkali-resistant, and water-resistant. Good sealing performance.
Physical Parameters
Color: White Solid Content: ≥70%.
Density: (1.60~1.80) g/ml. Flash Point: Above 25°C.
Drying Time: Surface dry in 30 minutes, fully dry in 24 hours. Temperature (23±2) °C. Theoretical coverage: (3~4) square meters/kg (dry film thickness 30 microns).
Mixing Ratio: A component:B component = 20:1 (by weight), subject to packaging label. Usable period: Use within 8 hours after mixing. Temperature (23±2) °C.
Storage: Store in a cool, dry place, effective storage period A component one year, B component six months. Packaging: 25 kg/set.
Surface Treatment
Surface Treatment: Before painting, the substrate surface should be clean, dry, flat, and firm, free of grease, rust, and other debris.
The moisture content of the substrate should be less than 8%, and the pH value should be less than 10.
Dust treatment: Can be cleaned with compressed air or a clean brush.
Old paint film treatment: Remove with a scraper, fill and sand smooth, or use other methods as appropriate. Mold treatment: First remove the mold with tools, apply anti-mold solvent, then wash with clean water and air dry. Grease treatment: First remove with a degreasing detergent, then thoroughly clean and air dry. Construction method: Suitable for scraping (only suitable for thin scraping, not for thick scraping).
Construction Conditions: Construction temperature (5~40) °C; relative humidity less than 75%, avoid construction in rain, snow, or fog, and prohibit contact with water and alcohols. Before construction, mix and stir A and B components according to the ratio, use after 30 minutes of maturation, and use within 8 hours. Recommended matching: Putty: D-NZ-7 fluorocarbon paint leveling putty.
D-NZ-8 fluorocarbon paint crack-resistant flexible putty (middle layer) D-NZ-10 oil-based putty (or D-NZ-9) Primer: D-FC-207 single-component epoxy sealing primer.
D-FC-206 fluorocarbon paint special intermediate paint Topcoat: D-FC series fluorocarbon topcoat Varnish: D-FC-205 fluorocarbon varnish.
Thinner: D-X-4 thinner, D-X-5 thinner. Film thickness: Wet film: 70 microns. Dry film: 30 microns.
Coating interval: minimum 12 hours, maximum 7 days, temperature (23±2) °C. Tool cleaning: D-X-4 thinner, D-X-5 thinner.
Safety and Environmental Protection Instructions
Avoid paint contact with skin and eyes; if contact occurs, rinse with clean water. The site must be well-ventilated. The paint contains flammable components, please keep away from sparks and prohibit smoking in nearby areas. Comply with all health and safety regulations on site.
Key words:
Oily putty D-NZ-10
Previous Page:
Message
Related Products
Message
* Note: Make sure you fill in the information accurately and keep the communication open, we will contact you as soon as possible.
Contact Us
No.19, Jingkai Second Avenue, Zhengzhou Economic and Technological Development Zone, China
Telephone
Page Copyright©Henan Dejiali Technology Group Co., Ltd.
Powered by :www.300.cn Supported IPV6 Privacy Agreement
